Descargar Imprimir esta página

Husqvarna T 4000 GP Manual Del Usuario página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Clean the spark arrester screen with commercial
solvent.
3. Examine the spark arrester screen for wear and
damage. Replace the spark arrester screen if it is
necessary.
CAUTION:
with a damaged spark arrester screen.
To do a check of the air filter
1. Remove the knob (A) and the air filter cover (B).
C
B
A
2. Remove the air filter (C).
3. Clean the air filter and the air filter cover with soap
water.
4. Let the air filter and the air filter cover become dry.
5. Install the air filter, the air filter cover and the knob.
To clean the dust extractor
It is important to clean the dust extractor to prevent
circulation of dangerous dust. Always clean the dust
extractor before it is moved from the work area.
Clean the external surface with a moist cloth.
Clean the filters and the dust extractor in applicable
area.
Clean the inner surfaces of the prefilter with a dust
extractor. Always use dust extractors with HEPA
filter and a soft brush to not do damage to the filter.
Do not use water on electrical components.
Do not clean the dust extractor with compressed air
or water.
Do not put tools on the surface of the filter, it can
cause damage to the filter.
Do not make a hole in the HEPA filter, it can cause a
health risk.
To clean the prefilter
Only use Husqvarna filters for best performance and
filtration efficiency.
Clean the prefilter before you change the Longopac,
when the operation is completed or when the suction
2065 - 003 - 04.03.2024
Do not use a generator
is unsatisfactory. The manometer on the dust extractor
points at the red area when the suction is unsatisfactory.
CAUTION:
across the filter surface as this will do
damage to the filter.
1. Start the product, refer to
on page 12 .
2. Close the inlet with the inlet valve.
3. Let the dust extractor make vacuum for 5 seconds,
then push and hold down the Jet Pulse handle for
5 seconds. Do this step 5 times. It is important to
let the dust extractor make vacuum after you release
the Jet Pulse handle.
4. If the suction continues to be unsatisfactory, replace
the filter.
5. Replace the Longopac when the prefilter is clean,
To replace the prefilter on page 17 .
refer to
To replace the prefilter
WARNING:
protective equipment when you replace
the prefilter. Refer to
equipment on page 6 .
1. Stop the product, refer to
on page 13 .
2. Make sure that the fan fully stops before you open
the dust extractor.
3. Loosen the 3 toggle fasteners and remove the top.
4. Remove the plastic bag from the new filter.
5. Lift out the prefilter from the dust extractor and
position it carefully in the plastic bag.
WARNING:
must be correctly disposed.
6. Install the new prefilter.
To replace the HEPA filter
WARNING:
The HEPA filter will break if you clean it.
WARNING:
the new HEPA filter. Do not touch the inner
surface of the HEPA filter, it will break by all
types of force or damage.
WARNING:
protective equipment when you change the
Do not hit or drag items
To start the dust extractor
Use correct personal
Personal protective
To stop the dust extractor
This plastic bag
Do not clean a HEPA filter.
Be careful when you install
Use correct personal
17

Publicidad

loading

Este manual también es adecuado para:

T 4000 gp soff-cut