Publicidad
Idiomas disponibles
Idiomas disponibles
Filling the Clean Tank
C1
C1–1—
Hold the upper part of handle firmly,
and pull out the clean tank.
C1–2—
Open the plug, fill it with tap water,
and then close it tightly. The water
level should not exceed the MAX
line, then close the plug tightly.
C1–3—
Tilt the clean tank, install the bottom
in place, and then gently push it
inward until it clicks in place.
Notes:
• To avoid deforming the clean tank, only use cold water.
• To prevent any potential damage to the clean tank,
do not use any disinfectant and only use detergent
recommended by Roborock.
Locking and Unlocking
C2
C2–1—
Tap one side of the cleaning head
and push the handle to lock the
cleaning head or pull the handle to
unlock the cleaning head.
C2–2—
Locked
C2–3—
Unlocked
Starting the Vacuum Cleaner
C3
Unlock the cleaning head and press the
button to start the vacuum cleaner.
Notes:
• The cleaning head does not work when locked. Unlock
it first.
• Press the
button to start or stop drying while the
vacuum cleaner is charging.
Low-Profile Cleaning
C4
1. When lowering the handle during
operation, the vacuum cleaner can be
positioned flat to clean low-lying areas.
Please be aware that when the vacuum
cleaner is in this flat position, the usable
volume of the dirty tank is reduced.
Therefore, we recommend cleaning the
dirty tank before tackling low-lying.
2. When the vacuum cleaner is laid flat for
cleaning, it will automatically adjust its
operating mode.
Note:
The vacuum cleaner can only be laid flat when
the Self-Clean button faces up.
Switching Modes
C5
Press the
button to switch to AUTO, MAX,
or ECO mode. The screen will display the
icon for the current mode.
Note:
When the vacuum cleaner is laid flat for cleaning
or when there is a significant amount of water on the
floor, it will automatically adjust its operating mode to
prevent sewage from entering, and there will be no
response when switching between modes.
Standby and Power Off
1. When the vacuum cleaner is operating,
press the
button to pause it and enter
standby mode.
2. In standby mode, you can lock the
cleaning head and place the vacuum
cleaner upright on the floor.
3. Lock the cleaning head and press and
hold the
button for 2 seconds to turn
off the vacuum cleaner. If the vacuum
cleaner is left idle for 5 minutes in standby
mode, it will automatically turn off.
05
Adding and Emptying Water
C6
When the dirty tank is full or the clean tank
is empty during use, the vacuum cleaner
will provide audio and visual alerts. Add
water into the clean tank or empty the dirty
tank before continuing.
Emptying the Dirty Tank
C7
C7–1— Hold the body of the dirty tank
with one hand, push the dirty tank
release with another hand, and then
remove the tank.
C7–2— Gently lift out the handle of the
cover to remove it, and then pour
out the dirty water.
C7–3— Reinstall the cover, tilt the dirty tank,
install the bottom in place, and then
gently push the tank inward until it
clicks in place.
Charging and Self-Cleaning
C8
1. Lock the cleaning head, and place the
vacuum cleaner onto the charging dock.
The voice alert "Start Charging" indicates
that the vacuum cleaner is charging.
2. Press the
button on the top of the
handle to start self-cleaning. Press and
hold the
button for 2 seconds to start
DEEP self-cleaning.
3. After self-cleaning finishes, empty the
dirty tank to prevent odors.
Publicidad
