Mounting The Bar Speaker On A Wall - Sony HT-CT180 Manual De Instrucciones

F:\HT-CZ1-11_UC2\4559026111\4559026111HTCT180UC2\01GB-
HTCT180UC2\060OTH.fm
010COV.book Page 12 Tuesday, December 2, 2014 2:44 PM
Mounting the Bar
Speaker on a wall
You can mount the Bar Speaker on a
wall.
Notes
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that
are suitable for the holes on the
rear of the Bar Speaker.
More than 30 mm (1
Hole on the rear of the Bar Speaker
12
GB
3
4 mm ( / in)
16
3
/ in)
16
4.6 mm
3
( / in)
16
9 mm
9
( / in)
25
2
Fasten the screws to 2 studs in the
wall.
The screws should protrude by
8 mm to 9 mm (approx.
8 mm to
9 mm
(approx.
11
/ in)
32
3
Hang the Bar Speaker on the
screws.
Align the holes at the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.
4-559-026-11(1)
masterpage: Left
11
/ in).
32
560 mm
1
(22 / in)
20
HT-CT180