Publicidad
Idiomas disponibles
Idiomas disponibles
3. Attach the provided cap nut to the wall mount screw.
4. Use the 10mm socket wrench and tighten the screws.
5. Remove the cap nut.
6. Make sure there is a recess of 8-9mm (5/16"-3/8"). If not, use the Phillips screw
driver and tighten or loosen until there is a recess of 8-9mm (5/16"-3/8").
<Side View>
7. Mount the grab bar onto the screws and secure with washers and nuts
using the 10mm wrench.
Stud,
Back Support
INSTALLATION PROCEDURE
Stud,
Back Support
Wall Mount
Screw
5/16"~3/8"
[8~9mm]
Finished Wall
Stud
Washer
<Side View>
Stud,
Back Support
Nut
6
Stud,
Back Support
Wall Mount
Screw
5/16"~3/8"
[8~9mm]
Finished Wall
Stud,
Back Support
<Side View>
Finished Wall
Publicidad
