Programmed Maintenance; General Warnings; Scheduled Maintenance; Cleaning And Maintenance Of Vacuum Chamber Packaging Machines - Orved MULTIPLE 315VM P4-P8 Manual De Uso Y Mantenimiento

Tabla de contenido

Idiomas disponibles

MAINTENANCE

7.1

GENERAL WARNINGS

ELECTRIC HAZARD!

Maintenance and/or repair operations on any of the appliance components must be done only after disconnecting the power

supplies (Disconnecting the plug from the mains).

ATTENTION!

Only qualified personnel must be allowed to carry out maintenance operations or access powered parts of the machine.

ELECTRIC HAZARD!

Disconnect the electric current before carrying out cleaning or maintenance.

For repairs, if necessary, contact a Service Centre authorized by the manufacturer. Use and demand genuine spare parts.

7.2

PROGRAMMED MAINTENANCE

FREQUENCY

Before each start up

Weekly

Every 15,000

operating cycles (about 100

hours of service)

Every 25,000

operating cycles (about 200

hours of service)

Every two oil changes

Every 1000

hours of service

Every 6 months

7.3

CARE AND CLEANING OF THE VACUUM PACKAGING MACHINE

ELECTRIC HAZARD!

Danger of electric shock ! Remove the machine plug from the power socket. Do not

use water or steam jets.

DANGER! Danger of burns: if alcohol-based or inflammable disinfectant products are

used, ventilate the area. Do not use naked flames near the machine! Do not smoke!

ATTENTION! Danger of injury! Use personal protective equipment. Do not use

caustic products, acids or aggressive products such as muriatic acid. Read the

instructions on the detergent product or disinfectant pack carefully.

WARNINGS! Use alcohol-based disinfectants.

The machine must be cleaned and disinfected every time after use.

Operation and maintenance manual / Ed. 10 - 2005

MACHINE PART

Pump

Power cable

Plexiglas cover

Red silicone

and Plexiglas cover gasket

Machine and vacuum chamber

Sealing bar connection wire

Sealing bar

Pump

Appliance with 4 - 8 - 12 m

/h pumps

Appliance with 18 - 25 - 40 - 60 - 100 m

Pump

40 - 60 - 100 mc/h pumps

Pump

Check the oil colour and level; top up the level,

or change it completely if the colour is dark or

whitish.

Check to make sure it is intact, replace if

damaged (Contact a specialist Service Centre).

Check to make sure it is intact; if cracks or

streaks are present, contact Customer service

for replacement.

Check to make sure they are inserted properly

in their seats; replace if damaged.

Clean to remove impurities, oil and grease.

Check to make sure it is connected.

Clean the upper part with a damp cloth.

Run the pump for about 30 minutes (using the

Pump or Jars function) to allow removal of

water from the pump oil.

Change the pump oil