Publicidad
Idiomas disponibles
Idiomas disponibles
•
If toward the left side of the deck, using wrench, turn the left adjustment
bolt clockwise 1/4 turn and the left adjustment bolt counter clockwise 1/4.
•
If toward the right side of the deck, turn the right adjustment bolt
clockwise 1/4 turn and the left adjustment bolt counter clockwise 1/4.
•
If the belt is still not centre, repeat the above step until the running belt is
on centre.
Lubrication
The treadmill is factory-lubricated. However, it is recommended to check the
lubrication of the treadmill regularly, to ensure an optimal operation of the
treadmill. It is usually not necessary to lubricate the treadmill in the first year
or the first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel
the surface of the belt, as far as possible. If traces of silicon spray are found,
lubrication is not necessary. In case of a dry surface refer to the following
instructions:
Application of lubricant on the belt:
•
Position the tape so that the seam is in the middle of the plate.
•
Place the dispenser cap on the lubricant container.
•
Start lubrication at the front end of the belt. Lubricate in the direction of
the rear end. Repeat this process on the other side of the tape. Grease
each side for approx. 4 seconds.
•
Wait 1 minute for the silicone spray to spread before starting the unit.
EN
73
Publicidad
