ARDES AR4BL1 Folleto De Instrucciones página 12

Product description:
(References: figure 1 at the back of the handbook)
1 – Air outlet grille
2 – Night light
3 – Control panel
4 – Base
5 – Air inlet grille
Batteries
The remote control is supplied with CR2025 3V batteries; remove the protective plastic from
the battery compartment of the remote control before use.
When the battery has run out, it must be replaced with another one of the same type.
To remove the battery, refer to the diagram shown on the back of the remote control and
figure 3 at the back of the handbook.
Description of controls:
(References: figures 1 and 2 at the back of the handbook)
To turn the device on, the plug must be inserted in the power socket and the switch (7) to
turned to "I".
"ON/OFF" button (A)
When the device is switched off, press this button to turn it on.
The device switches on in summer ventilation mode (indicator b3 on) and the display (h)
shows the room temperature.
When the device is switched on, press this button to turn it off.
"MODE" switch (B)
Press this button to change the operating mode; ventilation (indicator b3), minimum heating
(indicator b2) and maximum heating (indicators b1+ b2).
"LIGHT" button (C)
Press this button to change the colour of the night light (2): off, light blue, blue, purple, red.
The night light can be turned on even when the device is switched off, with the switch (7) on
I.
"TIMER" button (D)
Press the TIMER (D) button when the device is working to program automatic switch-off at
an interval of between 1 to 12 hours from when it is programmed. Every time the button is
pressed, the interval increases by one hour.
A few seconds after selecting the timer, the display will show the room temperature again.
When the timer function is activated, the indicator (d) lights up on the control panel. To
disable the timer function, press the timer button repeatedly until the display shows "0 0".
"SWING" button (E)
Press this button to activate or deactivate the automatic swing function of the device. When
the swing function is active, the corresponding indicator (e) lights up.
TEMP button (G) (F)
Press one of these buttons to set the desired room temperature (automatic function); the set
temperature will flash on the display (h).
USER INSTRUCTIONS
6 – Filter
7 – Main ON/OFF switch
8 – Grille hooks
9 - Remote control
12 / 39