Publicidad
Idiomas disponibles
Idiomas disponibles
1. Turn the rotary switch to " ". LCD display " ".
2. Connect the black test lead to the "COM" terminal and red
test lead to the " " terminal.
3. Measure the resistance of the circuit under test with the test
leads.
4. Read the measured resistance on the display.
NOTE:
When measuring low resistance, in order to measure
accurately, the measured resistance needs to subtract the
short-circuit resistance of the two test leads.
It is normal for high resistance measurement when it takes a
few seconds for the reading to stabilize.
5.3. Measure capacitance
In order to avoid damage to the meter or the equipment
under test, before measuring capacitance, the power supply
of the circuit under test should be cut off and all high-voltage
capacitors should be fully discharged.
1. Turn the rotary switch to "
2. Connect the black test lead to the "COM" terminal and red
test lead to the " " terminal.
3. Measure the capacitance of the circuit under test with the
test leads.
4. Read the measured capacitance on the display.
". LCD display "0.00nF".
35
Publicidad
