Vortice VORT T Manual De Instrucciones página 9

ENGLISH
CONFIGURATING BASIC PARAMETERS
The VORT T control box allows to control the ventilation based on the wind
speed (Mode A) or the temperature (Mode B), by using specific probes.
Generally the controller is equipped with a temperature probe and then
adjusted to an operation in B mode, relying on the temperature present in the
environment.
It is possible change mode every moment, following these steps:
• Shut the VORT T power unit down and then turn it on.
• Once turned it on, keep pushed SET button till 4 lines appear on the
display.
• Stop pushing the SET button.
To visualize in which mode you are operating, it is sufficient shut the control unit down and
then turn it on again (when switched on, '010A' or '010b' will appear on the screen depending
on the set mode).
The parameters control can be made in two ways: automatic or manual.
Automatic mode
This mode is recommended for the final user, because the control unit sets up the fan
functions in automatic and based on the data acquired, the fan speed is increased or
decreased. This is the default mode.
Manual mode
This mode allows to take control manually and modify , for example, the
number of RPM of the fan, independently of the microclimatic conditions.
This mode is suggested only during the initial test or in maintenance
conditions, in order to check out if everything is working properly. To enter
in this mode, push both ACTION buttons (UP-DOWN) for 5 sec. and push
again the UP-DOWN keys to change the fan speed (speed is expressed
as a percentage with a range from 0 to 100).
Note: to return to automatic mode it is necessary to press the two
UP-DOWN arrow keys simultaneously for approximately 5 seconds. Four lines will
appear on the screen and then the room temperature will be displayed.
Briefly, the ventilation control can be made by using:
• Wind Speed (Mod. A);
• Temperature (Mod. B).
The ventilation needs to be set up and configured with costant data.
Attention: not all parameters must be changed, because many of them are default ones.
SETTINGS
Mode B – Dominant parameter Temperature
Settings concern setting up the temperature in which fans start to move. To do this
push the SET button and click on INCR/DECR to regulate the temperature.
VORT T
9