Publicidad
Idiomas disponibles
Idiomas disponibles
_AutoDrain
_ Valve
More
than
1/100 slope
Filter
Stop
Regulator
Valve
Lubricator
Figure 1
Air Hose Hook Up
Main line = 3 times
Tool inlet/nose
size
Stop
Va ve
Air Compressor
This 3t8" Reversible
Pistol Grip Drill is designed to
operate on 90 PSlG. Lower pressure (below 90 PSlG) will
reduce performance
of the tool while higher air pressure
(over 90 PSlG) raises the performance
of the tool beyond
its rated capacity and could cause serious damage to
tool and user,
Warning:
Disconnect tool from air supply before
servicing or changing accessories.
Disconnect
air supply prior to changing bits. Drill bits
should be inserted as far as possible. Use approximately
sized chuck key to securely tighten ddll bit, lap or reamer
in drill chuck.. Always remove chuck key before connecting
to air iine,
Caution must be exercised
when using any
cutting tool because of the possibility of the
cutting tool bending or breaking. Cutting tool
maximum speed rating must equal or exceed
rated speed of tool,
High reaction torque may be experienced with
any drill at break through.
Lubrication
An in-line filter-regulator-lubricator
(fig 1) is recommended
as it increases tool life and keeps the tool in sustained
operation,, The in-line lubricator should be regularly
checked and filled with air tool oil,, Proper adiuslment of
1he in-line lubricator is performed by placing a sheet of
paper next to the tools exhaust ports and holding the
throttle open approximately
30 seconds. The lubricator is
properly set when a light stain of oil collects on the paper
Excessive amounts of oil should be avoided,,
In the event that it becomes necessary to store the tool for
an extended period of time (ovemight, weekend, etc), it
should receive a generous amount of lubrication through
the air inlet.. The tool should be run for approximately
30
seconds to ensure oit has been evenly distributed
throughout the tool.. The tool shou?d be stored in a clean
and dry environment.
Recommended
lubricants:
Use air tool oil or any other
high grade turbine oil containing moisture absorbent, rust
inhibitors, metal wetting agents and an EP (extreme
pressure)
additive..
Publicidad
