Garland FUM KEEPER 20V 310 M Manual De Instrucciones página 29

- Follow the advice below to ensure that the charge
capacity of your battery is maintained for as long as
possible:
- Avoid fully discharging the battery. Battery life will
be longer if you recharge the battery when you notice
your machine's power diminishing and don't let it run
out completely.
- Always recharge the battery after using the machine.
Do not store the battery discharged or half charged.
- Always recharge the battery inside your home and
garage to preserve the battery and charger from
humidity and inclement weather.
- Recharge the battery at temperatures between 5º
and 40º C.
- Always keep the battery away from water, humid
areas, heat sources and chemical products.
6.3.1 CHARGING THE BATTERY WITHOUT REMOVING
IT FROM THE SPRAYER (ONLY VALID WITH THE
KEEPER 20V DOUBLE SLOW CHARGER)
1. Insert the charging plug into the connector
indicated below
2. Connect the power cable to a 230 V socket.
3. Once the battery is charged the light on the
charger will turn green, unplug the charger from
the wall outlet and from the outlet on the sprayer
6.4. INSTALL THE BATTERY
Install the battery by sliding it along the rails (1) until it
makes a "clack" sound. This ensures that it will remain
securely connected to the machine.
To remove the battery, press the release button (2) and
pull the battery (3).
6.5. VERIFICATION POINTS BEFORE FILLING THE
DEPOSIT
Check the machine and look for loose parts (screws,
nuts, housings, etc.) and damages. Tighten, repair
or replace the parts that you have found in poor
condition.
Make sure there are no leaks or leaks in the battery
and that the battery is properly secured in the
machine.
Check the state of the lance and nozzle and that it is
correctly positioned.
Do not use the machine if it is damaged or improperly
regulated.
6.6. FILLING THE DEPOSIT
Always place this machine in a flat and safe place
before carrying out the filling operation.
Always fill the tank with the machine turned off and
the On / Off switch in the "O" position (open)
Fill the tank carefully and slowly to prevent the
liquid from overflowing out of the tank. If the liquid
overflows, clean it quickly with a dry cloth and prevent
the liquid from reaching the battery or motor of
the machine. The liquid can damage the electrical
equipment of this machine, reducing the useful life of
the product.
If you are going to fill the tank with a mixture of liquids
29/100
English
2
3