Virutex EVOLUTION PEB200 Manual De Instrucciones página 29

B
A
(Fig. 8)
A
(Fig. 9)
(Fig. 9.1)
8.2 Adjustment of the Edge Banding Height
The edge banding should be 3 or 4 mm higher than the piece
to be edged. Cut the edge banding 5 or 6 cm longer than the
piece to be glued.
1. Edge Banding Entry
To adjust the height of the edge banding A (Fig. 8) at the entry,
the entry guide B must be adjusted. Insert the edge banding
between the guides B. Loosen the adjustment knob C and adjust
the pressure foot D to the height of the edge banding to be
used according to the scale.
C
2. Edge Banding Exit
To adjust the height of the edge banding A (Fig. 9) at the exit,
position the edge banding as shown in the figure and lock the
position with the knob C (Fig. 9.1).
C
D
PEB250 EVOLUTION - 29