Publicidad
Idiomas disponibles
Idiomas disponibles
(Fig. 15)
B
(Fig. 14)
B
(Fig. 12)
(Fig. 13)
A
C
A
A
The control knob (Fig. 15) should not be moved once
the machine has cooled down. The control knob A
(Fig. 15) can only be moved: PEB250- After hearing
the Beep-Beep noise.
9.2 Controlling the gluing speed.
With a simple turn of the control, you can regulate the speed
while you continue banding. No need to stop.
To change the speed, you should turn handle A (Fig. 14) until
index C (Fig. 14) is set to the speed you require. Index C shows
the speed in m/min, (2-4-5-6).
The maximum speed is recommended for straight jobs and with
a low edge. The minimum speed is recommended for rounded
shapes with small internal radii and also for tall edges.
Removal of the glue tank cover.
Unscrew knob A (Fig. 12) three turns, move the cover forward
until it has been dislodged from the tank and lift it upwards
(Fig. 13) to remove it.
This operation must always be carried out with the
machine hot.
D
E
PEB250 EVOLUTION - 31
Publicidad
