Impecca RA-2180 Guia Del Usuario página 13

Caution!
• Don't use sharp objects as they are
likely to scratch the surface.
• Don't use thinner, car detergent,
Clorox, ethereal oil, abrasive
cleansers or organic solvent such
as Benzene for cleaning.They may
damage the surface of the appli-
ance and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
foodstocks are low. Wipe the inside of
the fridge freezer with a weak solution of
bicarbonate of soda, and then rinse with
warm water using a wrung-out sponge or
cloth. Wipe completely dry before replac-
ing the shelves and baskets. Thoroughly
dry all surfaces and removable parts
before putting them back into place.
Although this appliance automatically
defrosts, if the freezer door is opened
frequently or kept open too long, a layer
of frost may occur on the freezer com-
partment's interior walls. If the frost is too
thick, choose a time when the freezer is
nearly empty and proceed as follow:
1. Remove existing food and accesso-
ries baskets, unplug the appliance
from the mains power and leave the
doors open. Ventilate the room thor-
oughly to accelerate the process.
2. When defrosting is completed, clean
your freezer as described above.
Caution! Do not use sharp objects to
remove frost from the freezer compart-
ment. Only after the interior is completely
dry should the appliance be switched
back on and plugged back into the mains
socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
food and drinks can cause seals to stick
to the cabinet and tear when you open
the door. Wash seal with a mild detergent
and warm water. Rinse and dry it thor-
oughly after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning: The LED light should be re-
placed by a professional. If the LED light
is damaged, contact the customer help-
line for assistance. To replace the LED
light, the below steps can be followed:
1. Unplug your appliance.
2. Push the 3 buttons to the back of the
control display part with a thin blade
screwdriver, and then pull it down-
ward.
3. Hold the control display part with
one hand and pull it with the other
hand while pressing the connector
latch.
4. Replace LED light and snap it correct-
ly in place.
13