Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIO
WARNmNG:
Always wear safety goggles or safety glasses with side
shie!dswhen operatingtools. Failure to do so couldresult
inobjectsbeing throwninto youreyes, resultingin possible
serious injury.
KNOW YOUR DRILL
Before attempting to use your drill, familiarize yourself with
all operating features and safety requirements. See Figure
1.
CHARGING
YOUR DRILL
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you shouldcharge it
at least 5 hours prior to use.
NOTE: Batteries willnot reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to become fully charged.
TO CHARGE
[]
Charge battery pack only with the charger provided.
[]
Make sure power supply is normal house voltage,
120 volts, 60 Hz, AC only.
[]
Connect charger to battery pack by inserting charger
plug into input jack. As shown in figure 1, inputjack is
located on the back side of battery pack.
NOTE; Battery pack can remain on your drill or be
removed while charging. When battery pack is out of
the drill, be careful not to touch both terminals with a
metal object. Touching both terminals with a metal
object will short out the battery pack.
m
Make sure charger"plug and input jack are properly
connected.
6
Connect charger to power supply.
[]
The charge indicator light (LED), located on the battery
pack, will light up and glow when the charger is prop-
erly connected to power supply. This light indicates the
charger is operating properly. It will remain on until
charger is disconnected from power supply_ The light
only glows while your tool is charging, not during use.
i=
After' normal usage, a minimum of 3 to 5 hours of
charging time is required to be fully charged.
B
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
[]
DO NOT operate the tool while it is connected to the
charger. The driving ability' will not increase.,
[]
DO NOT place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
B!
CHUCK
CHUCKKEY
CHUCK
STORAGE
SELECTOR
SWITCHTRIGGER
WRISTSTRAP
CAUTION:
Your drill's
battery
pack contains
special
high
temperature batteries to help prevent battery damago
when left on charge for extended periods of time.
However, once the batteries become fully charged,
we recommend that you unplug the charger from
power supply and disconnect it from the battery pack.
CHARGE INDICATOR
LIGHT(LED)
INPUTJACK
BATTERYPACK
BATTERY
CHARGER
CHARGER PLUG
Fig1
Page 6
Publicidad
