Publicidad
Idiomas disponibles
Idiomas disponibles
2. PRODUCT INFORMATION
Intended use
This grass trimmer is intended for outdoor use,
to trim and to cut grass and lawns in private and
hobby gardens. The product is designed cutting
grass, light weeds and other similar vegetation
at or about ground level. The trimmer should
not be used to cut or trim hedges, bushes or
other vegetation where the cutting plane is not
at or about ground surface level. Do not use the
trimmer to shred or to make compost.
Technical specifications
Model No.
Voltage:
No-load speed:
Recommended battery:
Cutting width
Cutting system 2 line wire spool, Tap and go Ø1.2mm x 4m
Weight:
Sound pressure level:
Acoustic power level:
Vibration:
Rear handle
Front handle
Model No.
Battery Type:
Voltage:
Capacity:
Recommended charger:
Weight:
Only use the following batteries of the AX-POWER
12V battery platform. Using any other batteries
could cause serious injury or damage the tool.
CDA1192 12V, 1,5Ah Lithium-Ion (included)
The batteries of the AX-POWER 12V battery
platform are interchangeable with all the FERM
AX-POWER 12V battery platform tools
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60335-1 and EN 50636-2-91; it may be
used to compare one tool with another and
as a preliminary assessment of exposure to
vibration when using the tool for the applications
mentioned.
8
GTM1008
12V
9.000/min
CDA1192 12V DC - 1.5Ah
220mm
1.4 kg
LPA:71.3 dB(A) K=3dB(A)
LWA:88.3 dB(A) K=1.32dB(A)
2.63m/s²
1.24m/s² K=1.5m/s²
CDA1192
Lithium-Ion
12V
1.5Ah
USB (5V 1-2A)
0.18kg
- using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. Handle with softgrip
2. On/off switch
3. Safety switch
4. Battery indicator
5. Front handle
6. Main housing
7. Protection guard
8. Protection bar
9. Spool housing
10. Battery
11. Housing screws
12. Protections guard screw
13. Spool assembly
14. Spring
15. Spool housing
16. Battery release buttons
17. Charger cable
18. Charging indicator
3. ASSEMBLY
Before any work on the power tool,
remove the battery
The battery must be charged before first
use.
Removing the battery from the machine (Fig. D)
• Push the battery release buttons (16) and pull
the battery out of the machine (1).
Publicidad
