Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting the battery into the machine (Fig. C)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
• Insert the battery (10) into the base of the
machine (1).
• Push the battery further forward until it clicks
into place.
Charging the battery (with the charger) (Fig. E)
• Plug the USB-C connector of the charger
cable (17) into the battery (10).
• Plug the USB-A connector of the charger cable
into an USB power adapter (not included).
Alternatively, for example a powerbank or
laptop can be used as a power source.
• The charger indication light (18) will lighten up
and show the charging status.
LED indicator (7) Fig. E
The battery has 1 LED indicator (18) which
indicates the status of the charging process:
LED
Red
Green
Battery charging finished, battery fully charged
After the battery is fully charged remove the
charger plug from the outlet and unplug the
charging cable from the battery.
When the machine is not being used
over a longer period of time it is best to
store the battery in charged condition.
Before using, always visually inspect to
see that the blades, blade bolts and
cutter assembly are not worn or
damaged.
Warning! You may not use the grass
trimmer without the protection guard.
Mounting the Protection guard (Fig. C1)
• Place the protection guard (7) on to the
machine head as shown in Figure C1.
• Secure the guard using the screw (12)
delivered
• Insert the protection (8) into the slots on the
base (6).
Charger status
Battery charging in progress
Never attempt to remove the guard.
Mounting the housings (Fig. B)
• Insert the front handle (5) in to the middle
housing (6).
• Insert three main housing parts into each other
with are secure fit. Make sure the screw holes
align.
• Secure the housing screws (11) into the four
slots to assembly the main housing (6).
Before replacing the spool, clean the
machine from any dirt.
Replacing the spool (Fig. C2)
• Remove the spool assembly (13) but leave the
spring (14) inside.
• Take the replacement spool assembly and
place it over the spring (14).
• Fasten the spool assembly by turning the
spool tightly into the spool housing.
4. OPERATION
Using the tap and go system (Fig. C2)
• When the wire is too short, switch the machine
on and press the tip of the spool assembly (1)
on the ground (make sure this is done on a
hard surface).
• This will release the wire in order to get longer.
• The wire will be cut on the correct length
automatically by the blade mounted in the
protection guard (7).
Using your grass trimmer
• For your own safety and for the best results
read the following user advice and do not
use this product for anything other than its
intended purpose.
• This grass trimmer is made for cutting grass.
All other use that is not specifically allowed in
this manual may lead to damage to the grass
trimmer or injury to the user.
• Make sure that the work area is free of rock,
debris, lines and other objects.
• Start the tool before approaching the grass to
be cut.
• Cut the grass by swinging the tool from right
to left and proceed slowly keeping the trimmer
9
Publicidad
