Publicidad
Idiomas disponibles
Idiomas disponibles
Laundry
Fabric
Label
Synthetics
e.g. viscose,
polyester
Silk,
wool
Cotton,
EN
linen
Do not iron
THE STEAM CONTROL SWITCH
The amount of steam is regulated by the Steam control
switch.
1. Ensure there is water in the
Water tank.
2. Wait for the Temperature
indicator light to turn GREEN.
3. Set or turn off the continuous
steam output using the Steam
control switch.
NOTE: This function can be used
only when the Temperature control dial is set in the
range from
to MAX.
NOTE: The iron continuously emits steam only if you
hold it in a horizontal position.
You can stop the release of steam by standing the iron
on its heel or sliding the Steam control switch entirely to
the left.
ATTENTION: Do not use the steam function for silk
and synthetics so as not to damage the surface of the
fabric.
If the Temperature control dial is set to a lower setting,
to prevent potential dripping, the iron is equipped with
the ANTI-DRIP SYSTEM.
The anti-drip system automatically reduces the volume
of steam when ironing at low temperatures to prevent
dripping.
During use, the anti-drip system may emit a clicking
sound, particularly when heating up or when the iron is
cooling down. This is normal and indicates that the anti-
drip system is functioning correctly.
6
Temperature
Soleplate
Setting
Temperature
70~120°C
(158~248°F)
100~160°C
(212~320°F)
140~235°C
(248~455°F)
/
/
SPRAY SETTING
The spray function can be used at any
temperature setting. Use this function
to make wrinkle removal easier.
1. Ensure there is water in the Water
tank.
2. Aim the Spray nozzle towards the
garment.
3. Press the Spray button down
slowly for a jet or press quickly and firmly for a mist.
NOTE: Do not use the spray function on silk and
synthetics.
BURST OF STEAM
Use the Burst of steam function to
remove stubborn wrinkles or to press
in a sharp crease.
1. Ensure there is water in the Water
tank.
2. Wait for the Temperature indicator
light to turn GREEN.
3. Press the Burst of steam button
firmly to generate a strong flow of steam.
4. Wait at least 4 seconds before pressing the Burst of
steam button again.
NOTE: This function can be used only when the
Temperature control dial is set in the range from
to MAX.
ATTENTION: Do not use the Burst of steam function
on silk and synthetics.
VERTICAL STEAM
The iron can also be used vertically.
This is especially useful for getting
creases out of hanging clothes,
curtains, tapes-tries, etc. To steam
vertically, press the Burst of steam
button while holding the iron in the
upright position.
WARNING: Do not iron clothes while they are being
worn.
EN
7
Publicidad
