Publicidad
Idiomas disponibles
Idiomas disponibles
CLOSING UP COOLER
After completing water connections, close up the unit by reposi-
tioning the cooler back onto the installed cooler and reinstall four
screws securing front and back of cooler together.
Final Steps
Before turning unit on, ensure unit is plugged in, water supply to
pump is on, and there is correct ventilation, as shown on page 3 of
this manual.
ELECTRICAL SYSTEM
The electrical system does not require general maintenance. The following wiring diagram is supplied for reference only.
OPERATING INSTRUCTIONS
The MCP Series of Coolers has an electronic touch control panel in the
upper right hand corner.
Note: The MCP series coolers are controlled by three touch points on the
front panel or with the remote control
Power
Pressing the Power icon
on, the unit will start in the default setting (pump ON and Fan on HIGH).
After its initial use, the last operating settings (for fan and pump)
will be reinstated when the unit is turned on again.
Pressing the Power touch point when the unit is already running will turn both
fan and pump of
f.
After A Power Failure: Once power is restored, the unit will restart in the same settings as before power was lost.
Pump
Pressing the Pump icon
The pump must be on while operating the fan for the unit to operate as an evaporative cooler, though the unit can be used in fan
mode without the pump, if desired.
Note: For best results turn on the pump for a few minutes to wet the pads before operating the fan.
Fan
Pressing the Fan icon
Please Note: There is a two-second delay from the pressing of the button for the fan to engage or change speeds. This applies
to the front control panel and the remote control.
.
turns on the unit. When first plugged, and turned
toggles the pump on and off. When the LED is lit, the pump is running.
cycles the unit from HIGH, to MEDIUM to LOW speeds and then OFF.
ITEM
Fan motor
Main pump
*Optional
purge pump
* Based on installation of owner
installed purge MCP44-PPK pump.
PURGE PUMP
PROGRAMMING
INDICATOR LIGHTS
PRESS TO
TURN ON
7
ITEM C
Electrical Specifications
VOLTS/AMPS
120 V; 2.8 amps
120 V; 0.9 amps
120 V; 0.9 amps
FAN SPEED INDICATOR LIGHTS
FAN
HI
M
ED LO
POWER
M
PU
P
PUMP POWER INDICATOR
Publicidad
