Your new appliance
Page 2 shows an overall view of your new appliance as well as
the burner power.
Accessories
The following accessories can be purchased from the
Technical Assistance Service:
Gas burners
Remove the plastic covering used to protect the stainless steel
before using the appliance (depending on the model). If any
traces of adhesive remain on the printed areas, remove them
with a wet cloth.
There are indications to show which burner each control knob
operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.
Additional coffee maker
support
Only for use on the auxiliary
burner with pans which are no
more than 12 cm in diameter.
Simmer Plate
This accessory has been
designed to reduce the level
of heat at the lowest power
setting.
Place the accessory directly
on the pan support with the
cones facing upwards, never
directly over the burner. Cen-
tre the pan over the acces-
sory.
--------
Code
HEZ298114 Additional coffee maker support
HEZ298105 Simmer Plate
HEZ298104 Simmer Cap
The manufacturer accepts no liability if these accessories are
not used or are used incorrectly.
Switching on manually
1.
Press the chosen burner control knob and turn it
anticlockwise to the required setting.
Use any type of lighter or flame (cigarette lighter, matches,
2.
etc.) and bring it close to the burner.
Switching on automatically
If your hob can be switched on automatically (ignition
sparkers):
1.
Press the chosen burner control knob and turn it
anticlockwise to the maximum power setting.
While the control knob is still pressed down, sparks are
produced on all burners. The flame ignites.
Release the control knob.
2.
Turn the control knob to the required setting.
3.
If it does not come on, turn the control knob to the off setting
and repeat the steps above. This time, press and hold the
control knob for longer (up to 10 seconds).
:
Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off the
burner and open a nearby window or door. Wait at least one
minute before trying to switch the burner back on.
Switching off a burner
Turn the corresponding control knob clockwise to the 0 setting.
Simmer Cap
Burner specially designed to
cook at minimum power. In
order to use it, remove the
auxiliary burner and replace it
with the Simmer Cap burner.
9