Princess 358640 Manual De Usuario página 9

Natural - (randomly cycle through different speed settings to
recreate an outdoor natural breeze)
Sleep - (slows down the fan speed so you can still feel the air
flow with reduced noise level)
• Sleep mode:
Firstly select the fan speed, then select sleep mode. The sleep
mode will begin from the selected fan speed and reduce down to
low speed where it will remain.
TIMER
• Press the TIMER icon to activate the timer. Push repeatedly to
increase the time. The timer can be set to automatically turn off
the fan after 1-24 hours.
SWING
• Press the SWING icon for the fan blades to oscillate, press again
to turn off.
COOLING
• Press the cooling icon for the cold function. Add the freezing ice
pack to the water reservoir for even cooler breeze. Pay attention
to the water level in the reservoir when the ice pack is added.
The water level must never exceed the maximum allowed.
STANDBY MODE
• When the unit is first plugged in, it will emit a beep and the unit
will enter standby mode.
• The display will not show data when in standby mode, if the Wi-Fi
is active it will dimly display only a flashing Wi-Fi icon.
Memory Function
• If the unit is turned off using the [ON/OFF] icon, the mode and
wind speed settings will be recalled when the unit is turned back
on.
• If the unit is shut down due to a power failure, the default setting
will override the previous settings.
Water level sensor
• The unit is featured with a water level sensor. In case of the
reservoir having too little water in when in cooling mode you will
receive a warning: the "COOL" icon will flash repeatedly for a few
seconds. In the Princess Home App you will also see an
indication that the water level is low.
CLEANING AND MAINTENANCE
• Always disconnect the power cord from the socket before any
cleaning.
• Clean the outside with a damp cloth. Never use harsh and
abrasive cleaners, steel wool or a scouring pad as this will
damage the device. Do not immerse in water or other liquid.
• To clean the water reservoir; Unlock the latch on the reservoir.
Open the water reservoir. Unscrew the screws holding the pump
to the water reservoir. Remove the water reservoir and clean it
with warm soapy water. After cleaning install the reservoir and
the screws to the unit.
• If the fan will not be used for a long period of time, drain the
condensate water and store it in a dry place.
Instruction manual
EN
9