Skil SL1814B-00 Manual Del Propietário página 19

TROUBLESHOOTING
Problem
Workpiece contact
element does not
depress fully. Tool
does not operate.
Tool operates
properly, but the
staples are not
fully driven into the
workpiece.
Tool operates
properly, but the
staples are driven
too deep into the
workpiece.
Tool jams frequently.
Magazine wobbles
when operating
Fig . 10
Cause
1. Too few staples in the magazine. 1. Reload the magazine with
2. Workpiece contact element is
jammed.
1. Depth of drive is not deep
enough.
2. Staples are too long for wood
hardness.
1. Depth of drive is too deep.
1. Incorrect staples.
2. Damaged staples.
3. Dirty magazine.
1. The bolts securing the magazine
are loose.
Tighten these
bolts if needed
Remedy
staples.
2. Remove the battery pack
and clear debris.
1. Adjust the depth of drive.
2. Use the staples length that
is appropriate for the wood
type.
1. Adjust the depth of drive.
1. Verify that the staples are of
correct size.
2. Replace staples.
3. Clean the magazine.
1. Tighten the loose bolts
with the two hex keys
(included). See Fig. 10.
19