Chauvin Arnoux PEL 115 Guia De Inicio Rapido página 6

INSTALLATION OF THE COLOUR-CODED IDENTIFIERS
For polyphase measurements, mark the current sensors, the voltage leads, and the terminals using the coloured rings
and inserts provided with the instrument, assigning one colour to each terminal.
■ Detach the appropriate inserts and place them in the holes above the terminals (the large ones for the current
terminals, the small ones for the voltage terminals).
■ Clip a ring of the same colour onto each end of the lead that will be connected to the terminal.
IN
VN V3
INDICATORS
Indicators
Green indicator: Mains
Indicator lit: the instrument is connected to mains by the external power supply (optional mains power unit).
Indicator off: the instrument is powered by the battery or by the voltage inputs.
Orange/red indicator: Battery
When the instrument is connected to mains, the battery is charged.
Indicator off: battery fully charged.
Indicator blinking orange: battery charging.
Indicator orange and blinking: battery is recovering from a full discharge.
Indicator red and blinking: battery low (and no mains power).
Red indicator: Phase order
Indicator off: phase order OK.
Indicator blinking: phase order incorrect.
Red indicator: Overshoot of the measurement range
Indicator off: no overshoot on the inputs.
OL
Indicator blinking once a second: at least one input is outside range limits, a lead is missing or is
connected to the wrong terminal.
Red/green indicator: SD card
Indicator lit green: the SD card is recognized and not locked.
Indicator lit red: SD card missing or locked.
Indicator blinking red: SD card being reset.
Indicator blinking alternately red and green: SD card full.
Indicator blinking light green: the SD card will be full before the recording in progress ends.
Green indicator: Wi-Fi
Indicator off: Wi-Fi is not activated.
Indicator lit: Wi-Fi is activated but not transmitting.
Indicator blinking: transmission by Wi-Fi in progress.
I3 I2 I1
V2 V1
VE/GND
Colour and function