Marshall JVM410H Manual De Instrucciones página 11

PROGRAMMING THE FOOTSWITCH
To enter footswitch program mode, press the
footswitch/MIDI program button on the front
panel once. The indicator light will illuminate.
This mode allows you to program the footswitch.
Note: when the front panel footswitch/MIDI
program switch is off, the footswitch will
execute commands the moment the switch is
pressed down. When the footswitch program
mode is active, you can use the amp as normal
with commands executed on release of the
footswitch.
To store the current amp status/settings to a
footswitch (preset store mode):
1. Press the footswitch/MIDI program button
on the front panel to enter Footswitch
program mode (red LED).
2. Press and hold the desired footswitch for
about 3 seconds. The FX footswitch LED will
flicker indicating that the preset has been
stored.
To store a specific front panel function to a
footswitch (switch store mode):
1. Press the footswitch/MIDI program button
on the front panel to enter Footswitch
program mode (red LED).
2. Press and hold the desired footswitch. While
holding the footswitch down, in less than 3
seconds, press the front panel switch you
want to map. The FX footswitch LED will
flicker a couple of times indicating that the
switch has been mapped.
Note: the footswitch/MIDI program switch
cannot be assigned to a footswitch.
The footswitch can be hot-swapped and
synchronises itself with the amp after
connection. Connect the footswitch lead to the
footswitch side first and then connect it to the
amp.
FOOTSWITCH RESET
Warning: once the memory is erased it cannot
be recovered.
To reset the footswitch to the factory default
status:
1. Unplug the footswitch at any of the cable
sides.
2. Press and hold the switch #6 (right switch).
3. Plug in the footswitch cord.
4. Release the switch and the FX LED will start
blinking.
5. If you want to erase the footswitch memory
press the switch #5. To keep the memory
press any of the #1-#4 switches.
6. Release the switch and the footswitch will
synchronise with the amplifier.
The factory default is as follows:
FSW #1: clean;
FSW #2: crunch;
FSW #3: OD1;
FSW #4: OD2;
FSW #5: master;
FSW #6: reverb.
ENGLISH
10