Publicidad
Idiomas disponibles
Idiomas disponibles
AIR SOURCE
Clean air at the correct pressure is essential to supply this tool. The working pressure for this tool is
specified in chapter "Technical data" and is recommended for most compressed air tools of this class.
An increase in pressure is required if the length of the air hose or other circumstances result in a
decrease in pressure. The air pressure has to be increased in order to guarantee the working
pressure at running tool. Water in the hose and compressor leads to a reduction in performance and
damage to compressed air devices.
RECOMMENDED COMPRESSED AIR SYSTEM
No.
1
Air tool
2
Air hose
3
Quick coupling
Oiler
4
(for tools with motor)
5
Pressure reducer
COMPONENTS
1
Oil collecting pan
2
Valve
3
Oil pipe
4
Vacuum gauge
5
Glass cylinder
6
Drain hose with shut off valve
7
Screw for fixing oil pipe
8
Oil tank
9
Air inlet connection with shut of valve
10
Vacuum generator
11
Glass cylinder shut off valve
12
Air inlet connection with shut off valve
13
Storage tube with dipstick probes
DRAIN ENGINE OIL
Set the oil pan (1) to the required height and fix the downpipe (3) with the fixing screw (7).
Open the ball valve (9), glass cylinder shut-off valve (11), the air shut-off valve (12) and the shut-off
valve on the tank drain hose (6) (at the bottom of the oil tank) and hang the tank drain hose on the
top of the oil collecting pan (1).
Drain the oil into the oil collecting pan (1).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Designation
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
No.
Designation
6
Drainage/filtering unit
7
Drainage valve
8
Shut-off valve
9
Dryer/filter unit
10
Compressor
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
