Connecting The Receiver; Insert Battery; Connecting The Telephone - Amplicomms BigTel 48 Manual De Instrucciones

3 Installation

3.1 Connecting the receiver

After unpacking your telephone, you must first connect the telephone recei-
ver to the base unit. The spiral cable needed for this has two identical con-
nections so that there can be no confusion. First take one end of the spiral
cable and plug it into the socket at the bottom of the receiver. Now plug the
other end into the socket on the left-hand side of the base unit.

3.2 Insert battery

Before connecting your new telephone to the telephone network, the sup-
plied battery should be installed. Please always use type AAA 1.5V alkaline
batteries. The batteries are required for the display and other features of the
telephone. Before installing or changing the batteries make sure that the
telephone is not connected to the telephone network. The battery compart-
ment is to be found on the underside of your telephone.
1. Open the battery compartment with a small screwdriver or a pointed
object.
2. Insert the battery. Ensure that the polarity is correct. Push the "-" pole
onto the small spring and then press the "+" pole downwards.
3. Close the battery compartment.
The battery must be changed when the display is no longer visible.

3.3 Connecting the telephone

Connect the telephone cable provided to the telephone jack and the tele-
phone socket on the rear of the telephone. The telephone works using the
TTD system (Touch-Tone Dialling).
I
NSTALLATION
17