Phonocar VM486 Manual De Instrucciones página 18

VM486
EN
4
GENERAL CONNECTION DIAGRAM
WARNING! Disconnect the negative terminal of the vehicle battery when making connections.
For additional cameras, proceed with the installation one camera at a time, keeping in mind that the pairing procedure
with the monitor should be carried out at a distance of no more than 15 m.
Once the pairing is done, the cameras can also be installed at a distance of more than 15 meters.
1
PROCEED TO INSTALL THE ADDITIONAL CAMERAS ONE AT A
TIME
(up to a maximum of 4 total cameras).
Disconnect the negative terminal of the vehicle battery.
- Make the connections before fixing the camera at a distance of no
more than 15 m to allow the pairing enable procedure to be carried
out with the monitor.
- Connect the additional camera to the power harness provided in
the package (3).
- Connect the black wire to ground and the red wire to an under-key
positive (+15) or vehicle position/marker light.
- Reconnect the negative terminal of the vehicle battery.
- Turn on the panel and proceed to enable the new camera on the
monitor, see Chapter 5 "MANUAL CAMERA ENABLE/DISABLE".
- After enabling it, pair the camera with the monitor, see Chapter 6
"PAIRING CAMERAS AND MONITORS".
- Verify successful pairing by clicking on the "CHANNEL" button (D)
on the monitor to display the paired camera.
Repeat the operation for all additional cameras.
3
3
18
POWER SUPPLY WIRING
mass
positive under key