Publicidad
Idiomas disponibles
Idiomas disponibles
Unit storage
1. Unscrew the drainage cover, unplug the water plug and discharge the water
inside the body.
2. Turn on the machine, adjust it to low-wind ventilation mode and maintain this
state until the drainage pipe becomes dry.
3. Turn off the machine, unplug the power plug and wrap the power cord around
the wrapping post. Install the water plus and the drainage cover.
4. Remove the exhaust pipe and keep it properly.
5. Cover the air conditioner with a plastic bag. Put the air conditioner in a dry place
and keep it out of the reach of children.
6. Remove batteries from the remote control and keep them properly.
Protection function
1. 1. Frost Protection Function:
In cooling, if the temperature of the *EVA pipe sensor is too low, the machine
will automatically enter protection status; if the temperature of the EVA pipe
sensor rises to a certain temperature, it can automatically revert to normal
operation.
* The EVA pipe sensor will help to detect the system temperature on the
evaporator, with purpose to achieve low temperature defrost protection and
high temperature protection.
2. Overflow Protection Function:
When water in the water pan exceeds the warning level, the machine will
automatically sound an alarm, and the W.F indicator will flash. At this point,
you need to drainage the water (details see Drainage Instructions at the end
of this chapter). After the water is emptied, the machine will get into standby
status.
3. Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay
booting protection function after the compressor is turned off.
Publicidad
