Bergstrom LITE Manual De Instrucciones página 21

LITE
• Check the terminal connections or possible cuts in communication cables (The
communication cable connects to the electronic control and to the compressor
module).
• Connect the cable clamps (in the electronic control and in the compressor module).
!
(If the error persists, contact the Authorised Technical Service).
• Take down the control panel's front panel and correctly connect the cable between
the control panel and the electronic control.
• This will disappear when the unit is in a position of less than 65º. Slant is detected
by the electronic control.
• Clear the wastewater channel obstruction (remove the outside cover of the unit for
access).
• Replace the EPDM seal (take down the unit and thoroughly clean the surface where
the EPDM seal is to be attached).
• Seal the cable output in the evaporator cover (remove the unit's outside cover for
access).
Solution
21
EN