Publicidad
Idiomas disponibles
Idiomas disponibles
Only use this product with the supplied power adaptor . Contact your retailer if the power
adaptor is damaged . Refer to the technical data of this product .
To avoid damaging the cord, do not place any objects on it or chafe it on sharp edges .
Keep it away from hot surfaces and open flames as well .
Lay out the cord in such a way that no unintentional pulling or tripping over is possible .
Keep the power adaptor and its cord out of reach of children .
When disconnecting the power adaptor from the electrical outlet, do not pull by the
connection cord but by the power adaptor .
Do not wrap the connection cord around the product .
Connect the power adaptor to an electrical outlet that is always easily reachable so that in
case of an emergency the plug can be unplugged immediately .
Pull the power adaptor out of the power supply to completely disconnect the product from
the mains network .
The power adaptor continues to draw a small amount of electricity, even without the
radio being operated, as long as the power adaptor is connected to the power supply . To
completely switch off the power adaptor, it must be disconnected from the mains network .
Do not subject the product to physical shock or strong vibrations .
If smoke or unusual sounds are observed, immediately unplug the power adaptor from the
power supply .
The power adaptor shall not be covered .
Disconnect the power adaptor from the power supply when the product is not in use and
before cleaning .
Let the product dry completely before connecting it to the mains supply and before
storage . Allow the product to cool down completely before storage .
Do not insert any foreign objects into the product .
NOTE: This product is equipped with rubber feet to protect delicate surfaces . It cannot be
ruled out that furniture care agents will attack or damage the rubber feet .
˜ Initial start-up
Set up the product on a level surface . Do not to cover the ventilation slots and
loudspeaker
5 ]
[
Connect the coaxial power connector of the power adaptor
port
.
3 ]
[
Plug the power adaptor into a properly installed mains socket .
The product first displays
A DAB station search is started in the background .
The date and time are set automatically .
After this installation routine, the product is in standby mode .
Fully lay out the antenna
on the top of the product .
Time is not set
.
4 ]
[
[
17 ]
and time 00:00 .
to the power adaptor
GB/IE
29
Publicidad
