Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE
1. Touch
to power on/off. When unit is powered ON, the green LED will illuminate.
2. Select desired fan speed by pressing
to increase fan speed or
Speeds are Low, Medium Low, Medium, Medium High and High.
3. Press
to turn Oscillation on/off. The default oscillation range is 90°. To activate 180° oscillation range, press and hold oscillation button for 3
seconds.
4. Press
to turn ambient lighting on/off and to cycle through brightness levels.
TIP: To turn fan speed and oscillation OFF while maintaining the ambient light setting, press and hold
Note: When the unit is plugged in, it will oscillate until it locates it's "default" position as part of the setup process. Following this, standard
operation will begin.
AMBIENT LIGHTING
POWER ON/OFF
GREEN LED LIGHT
OSCILLATION
10 English
to decrease fan speed.
for 2 seconds.
TIP: To maximize airflow, position the
tower so the front VORNADO logo
(located at base of tower) faces the
direction you want the tower to blow.
SPEED ADJUSTMENT
REMOTE CONTROL
REMOTE FUNCTIONS
POWER ON/OFF
SIDE BUTTON
OSCILLATION
SPEED ADJUSTMENT
1. Press
to power on/off.
2. Select desired fan speed setting by pressing
3. Press
to turn Oscillation on/off. Press and hold
for three seconds to change oscillation angle to 180°.
4. Press the Side Button to turn ambient lighting on/off
and to cycle through brightness levels.
REMOTE SETUP
The remote that comes with your unit is paired and ready to use out
of the box. If you need to pair a remote, follow these steps:
1. Plug the unit in, but do not press
to turn product on.
/
2. Remove pull tab completely from the remote.
3. Press
on the unit. The green LED will begin flashing.
4. Press and hold
on remote for 3 seconds.
5. The green LED will stop flashing when remote has been successfully
paired.
BATTERY REPLACEMENT
Your remote includes (1) coin style 3V CR2032 battery. Battery comes
pre-installed. Remove battery pull tab before first use. Pre-installed
battery has a one-year life expectancy (dependent on use) after pull
tab has been removed from remote.
1. For battery replacement, the remote requires one coin style 3V
CR2032 battery. Always use the correct size and grade of battery for
this product.
/
2. To replace battery, open battery door on the back side of the
remote control (you will need to loosen the small screw on door
using a #1 Phillips screwdriver). If necessary, clean the battery
or
.
contacts and also those of the device prior to battery installation.
Remove any plastic protection from the battery and place it
in the remote with the + side facing out. Ensure the battery is
installed correctly with regard to polarity. Replace the battery door
and screw.
Note: Remove battery from the remote control when not in use for an
extended period of time and always remove dead battery immediately
and replace with fresh. Do not store dead battery in remote.
WARNING: This product contains a button battery. If swallowed,
it could cause severe injury or death in just 2 hours. Seek medical
attention immediately.
11
English
Publicidad
