Publicidad
Idiomas disponibles
Idiomas disponibles
CA 200P4
FEATURES
• Stereo output.
• Pulse Width Modulated (PWM) MOSFET Power Supply.
• Variable input sensitivity: RCA input 0.2V to
• Thermal-, Overload- and Shortcircuit protection.
• Excellent muting circuitry assures no turn on/off
• Built-in High
/
Low Pass Filter
• Gold plated power connectors for optimal power distribution.
• European design and engineering.
• Gold plated speaker connectors for optimal signal output.
MOUNTING
The amplifier has to have at least 5 cm (2")
away from the amplifier. Be sure that the power and signal cables can enter and leave the amplifier
in a straight
line,
to avoid the risk of malfunction. Always place the power- and signalcables at
opposite sides of the vehicle to reduce any
The amplifier should be protected from exposure to moisture and direct sunlight.
Mark the mounting surface using the
holes at the marked locations and mount the amplifier using the supplied self-tapping screws.
INSTALLATION
Remember to always disconnect battery ground before working on a vehicle's electrical system!
Always place a fuse or circuit breaker no more than 30 cm (12") from the battery, no greater than
the fuse(s) of your amplifier for optimal
GETTING YOUR POWER STARTED
• First, the +12V terminal is connected directly to the battery of your car. Use a cable of at
least 25
mm' ,
and make sure that the connectors are of the same value.
- Don't forget the extra
- The +12V terminal should NOT be connected to the car fuse
• Second, the ground terminal (GND) must be fastened securely to the chassis of the vehicle
with the same
mm'
through it). Ensure that all
area where you want to make your ground connection to.
• Third, the last cable to connect is your remote turn-on
CD-players have an output terminal for connection of the REM of an
have such an
output,
function.
SIGNAL INPUT
The Caliber Amplifiers offer you two possibilities for your signal input.
• A High Level
input,
using the loudspeaker output from your radio and the special High Level
inputplug you found in the box.
• Signal input by using a RCA cable from your radio's RCA outputs to the amplifiers signal
input RCA's.
NEVER USE THE HI INPUT AND RCA INPUT AT THE SAME TIME!
Manual
3V.
ventilation
noises.
amplifier
as a template, then drill 2.5 mm (1/8") diameter
protection.
"Vehicle
protection
"
fuse.
cable as the positive cable (the same amount of power has to run
paint,
undercoating or any other insulation is removed from the
a separate switch must be installed to control your amplifiers on/off
'pops'.
space at all
sides,
to allow the heat to rise
box.
(REM).
Many radio-cassette and
amplifier.
If you don't
Publicidad
