Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3: Manual frequency selection
Short press (tap) the "▲" up and "▼"
down buttons to select the desired
frequency.
*NOTE:
For PWR-6000, press the "▲"
up and "▼" down buttons to sel-
ect the desired channel first. The
selected channel will flash, and
please press SET to confirm.
Then follow the step above.
①
▲
G.
CH
2s
SET
▼
The receiver is scanning
the best frequency.
Step 4: Pair up the receiver and transmitters
① One short press of the SET button again to initiate the IR synchronization.
② Vertically aim the IR window of a transmitter to that of the receiver.
③ After the successful synchronization, the receiver shows the
And the receiver and the transmitter shows the same channel number on the screen for the
designated channel.
*NOTE:
The signal indicator " ANT " indicates the frequency is successfully synchronized.
The audio indicator "
①
VERTICALLY
▲
G.
CH
SET
▼
AutoScan frequency selection
②
▲
G.
CH
SET
▼
The best frequency
is found.
(
)
" flashes to indicate the frequency is receiving audio signals.
)
ANT
(
)
IR
▲
VERTICALLY
SET
MHz
▼
G.
CH
®
Step 3: AutoScan frequency selection
① Long press (2s) the SET button of the receiver to
initiate the auto-scan function, which searches for
the best frequency in the RF environment.
② Wait until the new frequency appears on the screen.
*NOTE:
For PWR-6000, press the "▲" up and "▼" down
buttons to select the desired channel first. The
selected channel will flash, and please press
SET to confirm. Then follow the steps above.
▲
MHz
SET
▼
first, and then scan the frequency.
" ANT "
②
IR
▲
SET
MHz
▼
Turn on the
bodypack transmitter
7
*NOTE
PWR-6000
Select and confirm the channel
indicator on the LCD screen.
③
*NOTE
▲
SET
▼
IR
▲
SET
▼
(
(
(
(
ANT
(
(
Publicidad
