PHENYX PRO PTU-71 Serie Manual Del Usuario página 9

① Power button: Powers on/off the unit. It lights green when the unit is on.
② Volume control knobs: Twist these knobs clockwise/counterclockwise to increase/decrease
the volume.
*NOTE:
Please check the corresponding name of each knob before adjusting the volume for the desired
channel properly.
③ Up button: Short press (tap) this button for frequency increment. Long press for 2 seconds
to initiate the lock function.
*NOTE:
For PWR-6000, short press (tap) this button also for channel selection.
④ SET button: Short press (tap) this button for infrared synchronization setup. Long press for
2 seconds to initiate the auto-scan function.
⑤ Down button: Short press (tap) this button for frequency decrement.
*NOTE:
For PWR-6000, short press (tap) this button also for channel selection.
⑥ LCD screen: Displays the receiver status.
⑦ IR window: For infrared synchronization setup.
⑧ Antennas: For connecting detachable antennas and picking up signals from transmitters.
*NOTE:
The PWR-71 has two antennas, while the PWR-7000 and PWR-6000, respectively, have four.
⑨ 1/4" mixed output jack: The 1/4" (6.35mm) output jack accepts an unbalanced TS
connector.
⑩ XLR audio output jack: The XLR audio output jacks accept a balanced XLR connector.
⑪ DC power jack
Each channel has its corresponding XLR output jack.
① ②
G.
CH
⑤
Receiver LCD Screen
① Group number
③ ④
② Channel number
③ RF signal indicator: It appears when the transmitter
( )
( ANT )
is successfully paired up with the receiver. When it
disappears, the channel receives no signal.
MHz
④ Audio signal indicator: Indicates audio signal level.
" ANT " indicates no audio signal. "(
the highest audio signal level.
⑤ Frequency number
®
10
)" indicates
)
ANT
( )