Publicidad
Idiomas disponibles
Idiomas disponibles
For precision work, it is important that all accessories be in good balance (much the same as the tires on your automobile). To true up or balance an
accessory, slightly loosen collet nut and give the accessory or collet a 1/4 turn. Re tighten collet nut and run the Rotary Tool. You should be able to tell by
the sound and feel if your accessory is running in balance. Continue adjusting in this fashion until best balance is achieved.
★ The first step in using the multitool is to get the "feel" of it. Hold it in your hand and feel its weight and balance. Feel the taper of the housing. This taper permits the tool to be grasped
much like a pen or pencil.
★ Always hold the tool away from your face.
★ Accessories can be damaged during handling and can fly apart as they come up to speed.
★ When holding tool, do not cover the ventilation openings with your hand. Blocking the ventilation openings could cause the motor to overheat.
★ IMPORTANT! Practice on scrap material first to see how the tool's high-speed action performs.
★ Keep in mind that your multitool will perform best by allowing the speed, along with the correct DEPSTECH accessory and attachment, to do the work for you. Do not put pressure on the
tool during use, if possible. Instead, lower the spinning accessory lightly to the work surface and allow it to touch the point at which you want to begin. Concentrate on guiding the tool
over the work using very little pressure from your hand. Allow the accessory to do the work.
★ Usually it is better to make a series of passes with the tool rather than to do the entire job with one pass. A gentle touch gives the best control and reduces the chance of error.
For best control in close work, grip the multitool like a pencil
between your thumb and forefinger.
Balancing Accessories
Use
Getting Started
Holding The Tool
The "golf" grip method is used for heavier operations such as
grinding or cutting.
10
Publicidad
