Publicidad
Idiomas disponibles
Idiomas disponibles
ALWAYS TURN OFF THE TOOL BEFORE CHANGING ACCESSORIES, CHANGING COLLETS, OR SERVICING THE TOOL.
Important Charging Notes
1. The charger was designed to fast charge the battery only when the battery temperature is between 32°F (0°C) and 113°F (45°C). If the battery pack is too hot or too cold, the charger will
not fast charge the battery. (This may happen if the battery pack is hot from heavy use). When the battery temperature returns to between 32°F (0°C) and 113°F (45°C), the charger will
automatically begin charging.
2. A substantial drop in operating time per charge may mean that the battery pack is nearing the end of its life and should be replaced.
3. Remember to unplug charger during storage period.
4. If tool does not charge properly:
a. Check for voltage at outlet by plugging in some other electrical device.
b. Check to see if outlet is connected to a light switch which turns power "off" when lights are turned off.
Check charging base and power supply terminals for dirt. Clean with cotton swab and alcohol if necessary.
NOTE: Use of chargers or battery packs not sold by DEPSTECH will void the warranty.
FUEL GAUGE
This tool is equipped with a fuel gauge that tells you how much charge your battery has.
Normal charge
<6.8V
LED 1, LED 2, LED 3, LED 4 Blue light flashing
LED 1 BIue light is always on
<7.4V
<7.9V
LED 1, LED 2 Blue light is always on
LED 1, LED 2, LED 3 Blue light is always on
>7.9V
Full charge
LED 1~LED 4 Blue light is always on
Normal discharge
>7.5V
LED 1, LED 2, LED 3, LED 4 Blue light is always on
<7.5V
LED 1, LED 2, LED 3 Blue light is always on
<7.2V
LED 1, LED 2 Blue light is always on
<6.8V
LED 1 BIue light, is always on
<6.6V
Red light LED 1 flicker
Over Voltage Protection (UVP):
Main motor circuit discharge overcurrent (Main Discharge loop DOCP):
Short circuit current of main motor circuit (Discharge over current):
This will be a sudden stop as opposed to a gradual winding down of the tool. Simply recharge the tool and reuse.
★ Your DEPSTECH rotary tool does not come completely charged from the factory. Be sure to charge tool prior to initial use. Plug the power adapter jack onto the charging base and
insert the power adapter plug into your standard power outlet.
Assembly
Charging Battery Pack
LED 2, LED 3, LED 4 blue light flashing
LED 3, LED 4 blue light flashing
LED 4 blue light flashing
LED 4 blue light off
LED 3, LED 4 blue light off blue light off
LED 2, LED 3, LED 4 blue light off
Shut down directly
All blue lights are blinking
All blue lights are blinking
07
Publicidad
