Publicidad
Idiomas disponibles
Idiomas disponibles
9. Unplug the appliance
• After usage, unplug the appliance and let it cool down for at
least 2 hours before cleaning.
10. Clean after use
• Clean your appliance after each use.
• Before cleaning, let your appliance cool down for at least 2 hours.
• For cleaning instructions, refer to part 3. Clean all parts of the
appliance in BEFORE FIRST USE section.
11. Maintenance tips
• To ensure the durability of the cooking pot time over time, do
not cut food in it.
• Use the provided accessories. Do not use any metallic utensil as
it could damage the nonstick coating in the pot.
• After usage, the sealing gasket may keep the smell of your dish.
It is normal; silicone has little pores that open up when exposed
to high temperature and close back once temperature drops.
To eliminate the smell from the sealing gasket, you can:
−Put the silicone ring in the dishwasher
−Add 1 cup of vinegar, 1 cup of water and 1 lemon cut in large
pieces into the cooking pot and launch a steam program for 2
minutes, then let the steam release naturally.
• Change the sealing gasket every 2 years or earlier in case of damage.
234
TECHNICAL TROUBLESHOOTING GUIDE
Problem
Possible reasons
Unable to open because of
pressure in the cooking pot.
Unable to open lid
Pressure in the cooking pot
is fully released but the float
valve is stuck because it is too
dirty and therefore unable to
move down.
The sealing gasket is not
properly installed.
The cooking pot contains hot
ingredients generating steam.
Unable to close lid
The float valve is stuck because
it is too dirty and therefore
unable to move down.
Position and or direction at
which the lid was closed is
incorrect.
When opening the lid,
The sealing gasket created a
the cooking pot remains
suction effect.
attached to the lid.
Solutions
Press continuously the pressure release
button to remove the pressure inside
of the cooking pot. It can take a few
minutes until the pressure is fully
released.
a. Be sure the pressure is totally released
by letting the appliance cool down for
at least 2 hours.
b. Gently push the float valve down by
inserting a skewer or a long object
into the float valve opening. If this
does not work, send the appliance to
an Approved Service Centre.
c. For next use, please clean and dry off
the float valve thoroughly.
Install the sealing gasket properly.
Wait for the ingredients in the cooking
pot to cool down before trying to close
the lid again.
a. Gently push the float valve down by
inserting a skewer or a long object
EN
into the float valve opening. If this
does not work, send the appliance to
an Approved Service Centre.
b. For next use, please clean and dry off
the float valve thoroughly.
Close the lid in the correct direction
according to the instruction manual.
The cooking pot will free from the
lid by itself. It is normal and simply
demonstrates a good hermeticity of
the product. To avoid that the cooking
pot falls heavily on the product when
opening the lid, always open the lid
gently.
235
Publicidad
