Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use Accessory Tray
The unit is equipped with an accessory tray with places
to store your spray gun, nozzle extension with selector
nozzle, PerfectMix siphon, and high pressure hose.
NOTICE The accessory tray also has two spaces to
place PerfectMix detergent bottles (not included).
1. Place spray gun in wider groove on accessory tray
as shown.
2. Place nozzle extension with selector nozzle
attached in narrower groove on accessory tray.
3. Place blue PerfectMix siphon in small hole on
accessory tray.
4. Coil and place high pressure hose on hooks at
back of accessory tray as shown.
How to Use Selector Nozzle
The selector nozzle allows you to switch between five
different spray pattern nozzles. Spray patterns can be
changed while pressure washer is running once spray
gun trigger safety lock is engaged. The spray patterns
vary as shown below.
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
• NEVER change spray patterns without the trigger locked
on the spray gun.
• DO NOT twist selector nozzle while spraying.
3100 PSI
2.1 GPM
2800 PSI
2400 PSI
2.4 GPM
2.5 GPM
Follow these instructions to change nozzle
patterns:
1. Select desired spray pattern:
•
MAX - For stubborn or hard to reach surface
such as second story surfaces, paint removal,
oil stains, rust removal or other stubborn
substances (tar, gum, grease, wax, etc.).
•
GENERAL - For most all purpose cleaning
such as home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc..
•
DELICATE - For gentle cleaning of cars/trucks,
boats, RV's, patio furniture, lawn equipment,
etc..
•
FLUSH - For quick high flow clean up and
long reach cleaning of second story siding and
windows.
•
SOAP - For general soap applications or
to launch soap to second story siding and
windows.
2. Push button on selector nozzle, nozzle dial will pop
up.
3. Turn dial until desired spray pattern lines up with
button on selector nozzle.
4. Push dial in until it locks into place.
Usage Tips
• For most effective cleaning, keep selector nozzle
from 8 to 24 inches (20 to 61 cm) away from
cleaning surface.
• If you get selector nozzle too close, especially using
a high pressure spray pattern nozzle, you may
damage surface being cleaned.
• DO NOT get closer than 6 inches (15 cm) when
cleaning tires.
13
Publicidad
