Publicidad
Idiomas disponibles
Idiomas disponibles
In the event of a battery leak, remove the re-
chargeable batteries from the product immedi-
ately to prevent damage.
Remove the rechargeable batteries if the product
will not be used for an extended period.
Risk of product damage
Only use the battery type specified!
Insert the rechargeable batteries according to
the polarity marking (+) and (-) on the recharge-
able battery and the product.
Functioning
The integrated solar cell of the product converts so-
lar radiation into electrical energy and stores it in the
Ni-MH rechargeable battery. The product switches
on as it begins to get dark. The integrated LED is an
energy-saving illuminant with a very long life. The
light duration depends on the amount of sunlight, the
angle of light on the solar panel and the temperature
(the rechargeable battery capacity is temperature-
dependent). A vertical angle of light at temperatures
above the freezing point is ideal. The rechargeable
battery
will only achieve its maximum capacity
8
after several charging and discharging cycles.
Start-up
Mounting the product
Install the product in accordance with figure A.
Rotate the solar cell housing
wise out of the lamp shade
To switch on, set the ON / OFF switch
"ON" position, so the product turns on during
darkness (see fig. B).
Insert the solar cell housing
shade
and tighten by turning clockwise
3
(see fig. A).
Your product is now ready for use. You must
now decide whether you want to use your
product as a hanging lamp or a floor lamp.
Usage as a floor lamp:
Usage as a hanging lamp:
Tabletop use:
Choice of location:
counter-clock-
2
(see fig. A).
3
to the
7
into the lamp
2
Insert the rod
into the lamp shade
4
insert the ground stake
fig. A). At delivery, take note of whether the
ground stake
is inserted into the rod
5
with the spike. Remove, if necessary, the hanger
from the lamp shade
1
the handle outwards.
Insert the assembled product far enough into
the ground (lawn, flower bed) for it to be stable.
Make sure it is firmly placed. Do not use any
force when assembling or setting up the product,
e.g. hammer blows. This will damage the product.
Pull, if necessary, the rod
ground stake
out of the lamp shade
5
Attach the hanger
to the lamp shade by
1
inserting the endings of the hanger into the
admittance slots of the lamp shade.
The product can now be hung using the handle.
Remove the hanger
1
from the product and place the product on a
table. When doing so, make sure that the sur-
face of the table is flat and level.
In order to achieve the best result, set the product
up in a place where the solar cell will get direct
sunlight for as long as possible.
Make sure the solar cell is not impacted by other
light sources, e.g. yard or street lightening, or
the light will not switch on at dawn.
In low light the light will automatically switch on,
and automatically switch off in normal ambient
light.
Charge rechargeable battery
Switching the product on and off
Note that the product must be switched on
when the rechargeable battery is charging. The
rechargeable battery charging period using
the solar cell depends on the intensity of the
and
3
into the rod
(see
5
4
4
, by slightly bending
3
including the
4
.
3
and ground spike
5
GB/IE
11
Publicidad
