Silverline 427677 Traducción Del Manual Original página 10

GB
Troubleshooting
Problem Possible cause Solution
No power Switch on welder
Feed Roller (30) does not turn
Wire Feed Speed Dial (4) set to minimum 0 setting Increase setting
Incorrect roller pressure Adjust Tension Knob (31)
Feed Roller (30) turns but
Liner (36) damaged Check and replace Liner
Wire (27) does not feed
Wire welded to Tip (23) Release Wire from Tip
During use the welder stops Duty cycle exceeded and
Leave the welder for 20-30 minutes to cool down
working Over-Heat Indicator (5) is illuminated
Poor weld Incorrect current and feed settings Adjust Wire Feed Speed Dial (4) and 120/60A Switch (3)
10