KNOVA KN COM-50L Manual De Instrucciones página 3

GENERAL SAFETY INFORMATION CALIFORNIA PROPOSITION 65
WARNING
This product or its power cord may
contain chemicals known to the State of California to
cause cancer and birth defects or other reproductive harm.
Wash hands after handling.
WARNING
You can create dust
when you cut, sand, drill or grind
materials such as wood, paint, metal,
concrete, cement, or other masonry.
This dust often contains chemicals known
to cause cancer, birth defects, or other
reproductive harm. Wear protective gear.
GENERAL SAFETY INFORMATION
WARNING
Do not operate unit if damaged during
shipping, handling or use. Damage may result in
bursting and cause injury or property damage.
WARNING
Do not run unattended. Leaving
compressor in AUTO position may allow it to turn on
inadvertently. To prevent this and possible damage from
power surge, turn to OFF position after each use.
REMINDER: Keep your dated proof of purchase for
warranty purposes! Attach it to this manual or file it
for safekeeping.
Since the air compressor and other components (filters,
lubricators, hoses, etc.) used, make up a high pressure
pumping system, the following safety precautions must be
observed at all times:
1. Read all manuals included with this
product carefully. Be thoroughly familiar
with the controls and the proper use of
the equipment.
2. Follow all local electrical and safety codes
as well as in the US, National Electrical
Code (NEC) and Occupational Safety and
Health Act (OSHA).
3. Only persons well acquainted with these rules of safe
operation should be allowed to use the compressor.
4. Keep visitors away and NEVER allow children in
the work area.
5. Wear safety glasses and use hearing
protection when operating the pump
or unit.
6. Do not stand on or use the pump or unit
as a handhold.
7. Before each use, inspect compressed air system and
electrical components for signs of damage, deterioration,
weakness or leakage. Repair or replace defective
items before using.
DANGER
Breathable Air Warning
This compressor/pump is not equipped and should not
be used "as is" to supply breathing quality air. For any
application of air for human consumption, the air
compressor/pump will need to be fitted with suitable
in-line safety and alarm equipment. This additional
equipment is necessary to properly filter and purify
the air to meet minimal specifications for Grade D
breathing as described in Compressed Gas Association
Commodity Specification G 7.1 - 1966, OSHA 29
CFR 1910. 134, and/or Canadian Standards
Associations (CSA).
DISCLAIMER OF WARRANTIES
In the event the compressor is used for the purpose of
breathing air application and proper in-line safety and
alarm equipment is not simultaneously used, existing
warranties shall be voided, and the manufacturer
disclaims any liability whatsoever for any loss, personal
injury or damage.
8. Check all fasteners at frequent intervals for proper
tightness.
WARNING
Motors, electrical
equipment and controls can cause
electrical arcs that will ignite a fl ammable
gas or vapor. Never operate or repair
the unit near a fl ammable gas or vapor.
Never store fl ammable liquids or gases
in the vicinity of the compressor.
CAUTION
Compressor parts may
be hot even if the unit is stopped.
9. Keep fingers away from a running
compressor; fast moving and hot
parts will cause injury and/or burns.
10. If the equipment should start to abnormally vibrate,
STOP the engine/motor and check immediately for
the cause. Vibration is generally a warning of trouble.
11. To reduce fire hazard, keep engine/motor exterior
free of oil, solvent, or grease.
WARNING
Never remove or attempt to adjust
safety valve. Keep safety valve free from paint
and other accumulations.
DANGER
Never attempt to repair
or modify a tank! Welding, drilling
or any other modifi cation will weaken the
tank resulting in damage from rupture
or explosion. Always replace worn or
damaged tanks.
WARNING
Drain liquid from tank daily.
12. Tanks rust from moisture build-up, which weakens
the tank. Make sure to drain tank daily and inspect
periodically for unsafe conditions such as rust formation
and corrosion.
2