Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL SAFETY INFORMATION
13. Fast moving air will stir up dust and debris which may be
harmful. Release air slowly when draining moisture or
depressurizing the compressor system.
SPRAYING PRECAUTIONS
WARNING
Do not spray flammable materials in
vicinity of open fl ame or near ignition sources
including the compressor unit.
14. Do not smoke when spraying paint, insecticides,
or other flammable substances.
ASSEMBLY
HANDLE ASSEMBLY (Figure 1)
Lock Nuts
(Figure 1) Handle assembly
1. Place ends of handle around tank, behind the mounting
plate. Align holes in handle to holes in mounting plate.
2. Assemble four (4) screws and washers (from parts
package) through holes in mounting plate and handle.
Secure with lock nuts.
WARNING
Never use the handle to lift the unit
completely off the ground. Only use the handle to
lift one end so the wheels may be used to move the unit.
LUBRICATION
CAUTION
THIS UNIT IS SHIPPED WITHOUT OIL
IN PUMP! Follow lubrication instructions before
operating compressor.
Use oil shipped with the compressor. Do not use regular
automotive oil such as 10W-30. Additives in regular motor
oil can cause valve deposits and reduce pump life. For
maximum pump life, drain and replace oil after the first few
hours of run time.
The compressor pump takes approximately 280 ml (9.5 ozs.)
of oil. The sight glass, located on the crankcase portion of the
pump, is marked with "max" and "min" levels. Avoid
overfilling by adding oil gradually and checking the oil level
with the sight glass several times. Add enough oil to reach the
"max" level on the sight glass. Proper oil level is illustrated in
Figure 3.
15. Use a face mask/respirator when
spraying and spray in a well ventilated
area to prevent health and fire hazards.
16. Do not direct paint or other sprayed
material at the compressor. Locate
compressor as far away from the spraying
area as possible to minimize overspray
accumulation on the compressor.
17. When spraying or cleaning with solvents or toxic
chemicals, follow the instructions provided by the
chemical manufacturer.
WHEEL ASSEMBLY
(Figure 2)
Washers
Screws
(Figure 2) Wheel assembly
Wheel assembly kit includes:
- 2 wheels*
- 2 axle bolts*
- 2 lock washers*
- 2 nuts*
The items marked with an asterisk (*) were shipped loose
with the unit.
1. Wheel has an offset hub. With offset hub facing axle iron,
assemble axle bolt through holes in wheel and axle iron.
2. Place lock washer on axle bolt. Then tighten nut securely
to threaded part of axle bolt.
3. Repeat procedure with other side.
(Figure 3) - Proper oil level
3
Nuts
Lock
washer
Screws
Wheel
Max.
Min.
Publicidad
