Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
OPERATION OF YOUR FAN
USAGE
Fan Operation: Always operate the fan in the upright position following all
instructions and recommendations listed in this manual.
Fan Location: Place the fan in the area of the room that will provide proper fan
cooling. This fan can be placed in a window to provide additional
FRESH air from outside. In this location, the fan can also be used to
push inside air to the outside using the EXHAUST position.
Fan Connection: Plug fan directly into 120 volt A.C., 60 Hz wall outlet. Be sure plug
Note: To prevent overloading a circuit, do not plug the fan into a circuit that is
servicing other electrical needs.
Turning Fan On/Off: To start the fan, rotate Control Dial from 0 position to desired
Installation for Double Hung Window:
• If space allows, screens can be left in place.
• Legs should not be installed when mounting in window.
• Your fan comes fully assembled and is ready for window installation.
• This fan has been designed for a double hung window with minimum openings of
22 -1/2" wide x 11-1/8" high.
• Prior to installation, be sure the side panels are in the retracted position.
1. Open window at least 12".
2. Identify the front and back sides of the fan. For Fresh Air Operation (draw in fresh
air from the outside), position the fan so the front side faces you. See silkscreen
indicator under control dial "This Side - Fresh Air In". For Exhaust Air Operation
(pulls inside air out of the room), position the fan so the back side faces you. See
silkscreen indicator under control dial "This Side - Exhaust Out".
3. Place one hand under the fan and grasp the recessed handle around the Control
Dial with your other hand. With power cord aligned in its slot and coming inside
the house, position the bottom (lower edge) of the fan over the sill cap of the
window while still holding the recessed handle. Use your free hand to lower the
window sash down, making firm contact with the top of the fan (see Fig. 1). Secure
window sash in down position tight against the fan top. Note: It is the customers
responsibility to be sure the fan is secure in the window.
fits tightly in outlet. A loose connection may cause overheating and
damage to the plug or fan.
fan speed (I or II). Rotate dial to 0 to discontinue use. Unplug
fan when not in use.
Page 7
Publicidad
