Publicidad
Idiomas disponibles
Idiomas disponibles
The nail holder must be set to the length of the nails being
used. Pull up the spindle of the nail holder and rotate. The
arrow indicator that corresponds to the nail size being used
must be aligned with the notch in the magazine. Release
holder spindle so that it locks in place (see Figure 3).
CAUTION:
Failure to adjust nail holder height may result in
damage to advance mechanism.
Pull Up
ure 3 - Adjust Nail Holder for Length of Nail
•
Remove rubber band or tape holding nail coil. Place coil
over the spindle of nail holder in magazine (see Figure 4),
Figure 4 - Load Coil into the Magazine
Unwrap coil so that second nail can be placed between
sides of feed jaw. The ram (Fig. 10, No. 16) may need to be
pushed up to fit in the first nail. Make sure that the nail
heads are positioned in the slot at the top of the nail feed
rack (see Figure 5).
Second Nail Must Be
Positioned in Feed Jaw
Figure 5 - Load Nails Into Feed Jaw
•
Carefully close the magazine cover first. Then close the
door and secure in position with the latch. Make sure the
tab in the door holds the magazine cover in place
(see Figure 6).
Figure 6 - Close the Magazine Cover and Door
NAILING OPERATION
Refer to Figures 7 through 9 (page 5).
WARNING:
Read and follow all safety rules and operating
instructionsin this manual and on warning label of tool before
using this tool, Keep this manual with the tool.
WARNING:
Do not use this tool without safety warning
label, If label is missing, damaged or unreadable, contact
Sears to obtain a new label.
WARNING:
Never operate tool unless contact trip is in con-
tact with workpiece. Do not operate tool without fasteners or
damage to tool may result. Never fire fasteners into the air
because fasteners may injure operator or others and damage
to tool may result.
•
Perform "Safety Mechanism Check" as described in the
Maintenance section (see page 6) priorto first usa of tool
and on a daily basis thereafter.
4
Publicidad
