Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Nozzle Attachments
Your vacuum comes with nozzle attachments
to help you tackle daily or weekly cleanup job.
2-in-1 Crevice Tool
•
Press button to slide bristles up/down
and switch between crevice tool and
dusting brush. [Figure 4]
•
Use the crevice tool to clean hard-to-
reach places like crevices in furniture
and corners of a room or car.
•
Use the dusting brush to clean dust
and hard surfaces like mantels or
baseboards.
2-in-1 Pet Tool
•
Use the brush head to clean fur off soft
upholstery or pets.
•
Remove the brush head to use the fur
removal tool which loosens hair on
fabric and carpet. [Figure 5]
To use a nozzle attachment:
1.
Press and hold the Vacuum Body
Release Button and gently pull the
vacuum body from the stick.
2.
Slide the nozzle attachment onto the
vacuum body. [Figure 6]
3.
Optionally, leave the stick attached
to the vacuum body and press the
Vacuum Head Release Button to
remove the vacuum head. Then, attach
the nozzle attachment to the end of
the stick. [Figure 7]
Note: You can also attach the vacuum body
directly to the vacuum head.
6
CARE & MAINTENANCE
Battery Installation
1.
2.
Charging the Vacuum
Your vacuum uses a 2,200mAh Li-ion battery.
Use the included charger to charge the vacuum.
Note: Make sure the vacuum is turned off before
charging.
1.
2.
3.
4.
[Figure 8]
5.
Turn the vacuum off. Press the Battery
Release Button and remove the battery.
To reinstall, slide the battery into the slot
in the vacuum body. [Figure 9] There will
be a clicking sound when the battery is
properly installed.
Note:
•
To maintain the life of the battery, store the
vacuum in a cool, dry place.
•
Store the battery in a semi-charged state
(at least 2 battery indicator lights) and
maintain this by charging the battery every
3 months.
Install the wall mount by screwing it into
the wall near a power outlet. [Figure 10]
Note:
•
The wall mount must be high enough on
the wall to allow the vacuum to stand up.
•
Make sure that the wall is free of gas pipes,
water pipes, electrical cables, and wires.
Hang the vacuum on the wall mount.
[Figure 11]
Insert the charger into the charging port on
the battery. [Figure 11]
Plug the charger into the outlet. The
battery lights will blink while charging.
[Figure 11]
When the vacuum is fully charged, the 3
battery indicator lights will turn solid for 5
minutes, then turn off.
Publicidad
