Levoit LVAC-200 Manual Del Usuario página 12

EN
C L E A N I N G
Cleaning the Vacuum Body
1.
Turn the vacuum off.
2. Wipe the outside of the vacuum down with a
damp cloth.
3. Allow the vacuum to completely dry before
using.
Warning: Do not allow water to enter the
internal parts or motor of the vacuum.
Cleaning the Dust Bin & Metal
Filter
1.
Make sure the vacuum is off and the dust bin
is completely empty before cleaning (see
Emptying the Dust
2. Press the Dust Bin Release Button and pull
the dust bin to remove it. [Figure 14] Empty
out any remaining dust and debris, and
remove any hair tangled around the metal
filter.
3. Remove the pre-motor filters from the top of
the dust bin. Set aside or wash the pre-motor
filters (see Cleaning the Pre-Motor & Post-
Motor Filters, page 8).
4. Rotate the metal filter counterclockwise to
remove it. [Figure 15]
5. Rinse the dust bin and metal filter with water
and allow them to dry. Make sure the parts
are completely dry before using.
6.
Reattach the metal filter and replace the
pre-motor filters. Attach the dust bin to the
vacuum body.
Warning: Do not allow water to enter the
internal parts or motor of the vacuum.
Cleaning the Pre-Motor &
Post-Motor Filters
To maintain the performance of your filters, they
should be routinely washed and replaced.
•
If you notice decreased suction power,
or the filter is visibly dirty, clean the filter
immediately.
• The pre-motor filters (sponge and knitted
cotton) should be washed at least once a
month and replaced every 3 months.
8
Bin, page 7).
• The post-motor filter should be washed
at least once a year.
• Do not put filters in a dishwasher,
washing machine, tumble dryer, oven, or
microwave, or place near an open flame.
• Never
operate the vacuum without the
dust bin or filters properly installed.
•
Frequent use may require cleaning the
filters more often. Cleaning the filters
regularly helps maintain your vacuum's
cleaning performance.
•
You may need to replace the filters more
frequently depending on your use and
environment.
•
If the surrounding humidity is high, please
allow the filters to air-dry for a longer
period of time before reinstalling them
back into the vacuum.
Replacement Filters:
• To maintain the performance of your vacuum,
only use official Levoit filters. For more
information, contact
page 12).
Pre-Motor Filters
To maintain the performance of your filters, they
should be routinely washed and replaced.
1. Press the Dust Bin Release Button to
remove the dust bin. [Figure 14]
2. Remove the two pre-motor filters
(sponge and knitted cotton).
[Figure 16]
3.
Clean the pre-motor filters with water.
Allow the filters to air-dry completely
under the sun or in a dry, ventilated
place before reinstallation.
4.
Replace the sponge pre-motor filter,
followed by the cotton pre-motor filter.
Note: Make sure the cotton pre-motor filter
has the ribbon-handle side facing outward
when you insert the filter.
5. Place the dust bin back onto the
vacuum body.
Customer Support (see