Publicidad
EN
ORIGINAL INSTRUCTIONS
Safety, performance, and dependability have been given top
priority in the design of your clamp light.
INTENDED USE
The light is intended for both indoor and outdoor general
illumination.
The product is intended for use only when it is clamped. Do
not use the product with it resting on any surface.
With the magnetic function, the product can be attached to
horizontal metal surfaces only.
The product is not intended for clamping on smooth surfaces
or tubular materials.
When clamping, the material being clamped must be pushed
to the deepest point of the clamp for increased stability.
Do not place or hang anything on the product.
Do not use the product for any other purpose. Use of the
product for operations different from intended could result in
a hazardous situation.
LIGHT SAFETY WARNINGS
The light source of this luminaire is not replaceable.
When the light source reaches its end of life the whole
luminaire shall be replaced.
Use only with recommended battery pack and charger.
Any attempt to use another battery pack will cause
damage to the product and could possibly explode,
cause a fire, or personal injury.
Do not disassemble the product.
If wrapped or in contact with fabrics, the lens can
produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the lens to come in
contact with anything.
Do not place the product or battery pack near fire or
heat. This will reduce the risk of explosion and possible
injury.
Remove the battery pack or disconnect the mains power
before starting any work on the product.
Do not store the product in a damp or wet location, or in
a location where the temperature may reach or exceed
40°C. For example, inside sheds, vehicles, or metal
buildings in the summer.
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from
a distance). Staring into the light beam may result in
serious injury or vision loss.
With the magnets in the base, the product can be
mounted on a 22-gauge low carbon steel surface with a
minimum thickness of 0.6 mm.
BATTERY SAFETY WARNINGS
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool,
battery pack, or charger in fluid or allow fluid to flow inside
them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-
containing products, etc., can cause a short circuit.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
KNOW YOUR PRODUCT
See page 43.
1. On/Off button
2. Adjustable head
3. Pivoting collar
4. Battery cap
5. Magnetic clamp
6. USB charging cable
7. Battery
8. Operator's manual
9. USB power adaptor
MAINTENANCE
Use only original accessories and spare parts. Should
components that have not been described need to be
replaced, please contact an authorised service centre.
All repairs should be performed by an authorised service
centre.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
3
Publicidad
