cecotec MOUNTAIN VENTUS Manual De Instrucciones página 84

ENGLISH
6. Insert the front light and horn wires into the hole at the top of the diagonal tube. Bring the
accelerator cable and the two side brake sensor cables together and join them with the
help of two cable ties.
Assembling the reflectors
Slide the reflector holder into the slot provided on the back of the saddle post.
-
- Then slide the reflector bracket over the seat saddle post.
Tighten the screw of the reflector bracket once it is in the correct position using the
-
Phillips screwdriver.
Follow the same steps to mount the front reflector. Place it on the handlebars and
-
tighten the screw with the screwdriver.
Assembling the saddle post. Fig. 3
Lift the saddle tube lever and insert the saddle post. Finally, close the lock lever by pressing it
towards the frame.
Note: adjust the saddle height with the lever under the saddle.
Assembling the saddle
- For the saddle height pre-adjustment, the saddle should be at the same height as your
hip. Please note that the correct position should be one in which your hip is not tilted to
one side when the pedal is in its bottom position and your foot is fully engaged in the
pedal. Once the pre-adjustment has been made, finally adjust the saddle height, bearing
in mind that when the saddle is raised, the knee should be neither fully stretched nor very
bent when the pedal is at the bottom.
- Adjust the saddle properly to ensure maximum efficiency and comfort during exercise.
The saddle is in the correct position if the user has a slightly bent knee when one of the
pedals is at a 90-degree angle relative to the ground.
- To indicate the maximum height that the saddle can be adjusted, you will see vertical line
markings following the word MIN.
Front wheel mounting. Fig. 4
1. Place the electric bicycle frame upside down on a stable surface. This ensures that no
parts of the electric bike are damaged during assembly. Remove any packaging or zip ties
that may remain on the front wheel.
2. Stand in front of the front hub of the electric bike with the disc brake on the left. When
mounting the front wheel, make sure that the tyre fits.
Note: If the front wheel does not fit, the inside of the front brake calliper must be loosened.
3. Carefully stand the wheel upright and insert the fork brackets onto the fork bracket. Then
insert the front axle together with the lock-on quick release and nut on the other side of
the wheel. Once inserted, first tighten the nut, and then turn the lock-on quick release
84
MOUNTAIN VENTUS