Publicidad
Idiomas disponibles
Idiomas disponibles
Do not open the valve before the
air hose is connected.
Do not leave device on
Wear eye protection
Wear respiratory protection
Wear ear protection
Wear protective gloves
Guaranteed sound power level
96
2. Safety information
2.1 General safety instructions for power tools
WARNING
Read all safety information, instructions, illustrations and technical data provided with this power tool. Failure to comply
with the following instructions may result in electric shock, fire and/or serious injury.
KEEP ALL SAFETY INFORMATION AND INSTRUCTIONS FOR FUTURE REFERENCE.
The term "power tool" used in the safety instructions refers to mains-operated power tools (with mains lead) or battery-operated power tools (without mains
lead).
1) Workshop safety
a) Keep your work area clean and well lit. Clutter or unlit work areas may lead to accidents.
b) Do not operate the power tool in an explosive environment where flammable liquids, gases or dusts are present. Power tools produce sparks
that may ignite the dust or fumes.
c) Keep children and other persons away while using the power tool. Distraction may cause you to lose control of the power tool.
2) Electrical safety
a) The plug of the power tool must fit into the socket. The plug must not be modified in any way. Do not use adapter plugs together with
earthed power tools. Unmodified plugs and matching sockets reduce the risk of electric shock.
b) Avoid body contact with earthed surfaces such as those of pipes, heaters, cookers and refrigerators. There is an increased risk of electric shock
if your body is earthed.
c) Keep power tools away from rain or wet conditions. Water ingress into a power tool increases the risk of electric shock.
d) Do not misuse the power cord to carry or hang the power tool or to pull the plug out of the socket. Keep the connecting cable away from
heat, oil, sharp edges or moving parts. Damaged or tangled connecting cables increase the risk of electric shock.
e) When working with a power tool outdoors, only use extension cords that are also suitable for outdoor use. Using an extension cord suitable
for outdoor use reduces the risk of electric shock.
f) If operation of the power tool in a damp environment is unavoidable, use a residual current circuit breaker. Using a residual current circuit
breaker reduces the risk of electric shock.
3) Safety of persons
a) Be attentive, watch what you are doing and use common sense when working with a power tool. Do not use a power tool when you are
tired or under the influence of drugs, alcohol or medication. A moment of carelessness when using the power tool may result in serious injury.
b) Wear personal protective equipment and safety glasses always. Wearing personal protective equipment, such as a dust mask, non-slip safety shoes,
hard hat or ear protection, depending on the type and use of the power tool, reduces the risk of injury.
c) Avoid unintentional operation. Make sure the power tool is switched off before connecting it to the power supply and/or battery, picking
it up or carrying it. If you have your finger on the switch while carrying the power tool or connect the power tool to the power supply while it is switched
on, accidents may result.
8
GB/IE/NI/CY/MT
Noise emission values
Sound pressure level L
= 74 dB (A)
pA
Uncertainty K
= 1.94 dB
pA
Sound power level L
= 94 dB (A)
WA
Uncertainty K
= 1.94 dB
WA
Guaranteed sound power level: 96 dB (A)
Wear ear protection!
NOTE
- The noise level specified in these instructions has been measured ac-
cording to a standardized measurement procedure and can be used for
device comparison.
WARNING!
- Noise emissions during actual use of the device may differ from the
specified values, depending on the way in which the device is used, in
particular, what type of workpiece is being machined and what kind of
accessory is being used.
Publicidad
