Publicidad
Idiomas disponibles
Idiomas disponibles
8.3
ASSEMBLE THE GUIDE BAR AND THE
CHAIN
1.
Switch off the chainsaw and engage the chain
brake.
2.
Remove the battery.
3.
Remove the chain cover nuts with the wrench
(11).
4.
Remove the chain cover (14).
5.
Put the chain drive links (21) into the bar groove
(20).
6.
Put the chain cutters (22) in the direction of the
chain operation.
7.
Ensure the chain is put on in the correct direction
(do not assemble with the cutters backwards).
8.
Put the chain in position and make sure that the
loop is behind the guide bar.
9.
Hold the chain and bar.
10. Put the chain loop around the sprocket (16).
11. Make sure the chain tension pin hole (19) on the
guide bar fits correctly with the bolt (17).
English
12. Install the chain cover.
13. Tighten the chain. Refer to Adjust the chain
tension.
14. Tighten the nuts when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after
the first use, examine the tension and tighten the
chain if necessary.
8.4
INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1.
Align the ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
3.
When you hear a click, the battery pack is
installed.
8.5
REMOVE THE BATTERY PACK
1.
Push and hold the battery release button (18).
2.
Remove the battery pack from the machine.
9
NOTE
18
WARNING
EN
Publicidad
